Changing Feeder Conveyor Speed

NOTE: The variable speed feeder house changes the speed of the lower feederhouse shaft. The variable speed adjustment is for use with a corn head or row crop head. When using a platform, the variable drive must be slowed all the way down to prevent rapid wear to cutterbar parts.

The feeder conveyor chain can be set to two different speeds by selecting the drive sprocket on the right hand side of the lower shaft.

The feeder house is shipped from the factory with the right hand drive chain on the small sprocket (A) for slow speed.

A-Small Sprocket

HX,AG,SF6947 -19-01MAR99-1/2

NOTE: If you have material handling problems or crop damage, increase the conveyor speed by moving the right-hand drive chain to the larger sprocket (C).

To move the chain to the larger sprocket:

Open front shield.

Loosen nut (A) and push sprocket rearward.

Loosen nut (B) and move sprocket to upper position

Push in on coupler and move large sprocket (C) inward until it engages detent.

Engage chain onto sprocket

Move sprocket to center position (D) and tighten nut (B).

Use pry bar in holes of inside plate to move sprocket forward and tighten nut (A).

Close front shield.

A-Nut
B-Nut
C-Large Sprocket
D-Center Position

HX,AG,SF6947 -19-01MAR99-2/2