Adjusting Finger Bar (Spike-Tooth Cylinder)

Adjusting the finger bar is done from on top of the straw walkers.

CAUTION: Straw walkers are sharp. Put plywood, cardboard, etc. on them for protection especially your wrists and arms if using a pry bar to move the finger bar.

Under normal conditions the rear of the finger bar is kept in the bottom hole (A). If backfeeding is a problem, move rear of finger bar to the top hole (B).

To adjust finger bar, remove bolt and nut holding bushing in slot; then relocate.

A-Narrow Clearance Slot
B-Wide Clearance Slot
C-Beater
D-Cylinder

HX,AG,SF7127 -19-09OCT91-1/1