Cab Head Light Bulb Replacement and Adjustment

CAUTION: Raise feeder house all the way up and lower safety stop before standing on feeder house to replace or adjust these bulbs.

Read "SAFETY WHEN REPLACING HALOGEN BULBS".

NOTE: Center two head lamps are infrared. All others are halogen lamps.

Remove three screws (A) evenly and remove headlamp (B).

Disconnect wiring (C). Clean dirt from headlamp.

Push in and twist retainer ring (D) counterclockwise. Bulb pulls straight out.

When installing headlamp, adjust as follows:

IMPORTANT: Over tightening the screws until they bottom out can break the headlamp.

Start with the two end screws first, then the bottom screw last. Adjust the screws until all three tabs are flush with the panel.

A-Screws
B-Headlamp
C-Wiring
D-Retainer Ring

HX,AG,SF7164 -19-04MAR99-1/1