Header/Reel/Belt Pickup Pump Belt Replacement

IMPORTANT: It is not necessary to disconnect any hydraulic hoses to replace this belt.

Remove shields.

Loosen locking nut and idler adjustment nut (A).

Remove bolt (B).

Disconnect electric clutch connector (C).

Remove belt (D). Install new belt in reverse and check feeder house sheave gap.

Tighten adjustment nut until gauge aligns with washer.

Tighten locking nut.

A-Idler
B-Bolt
C-Electric Clutch Connector
D-Belt

HX,AG,SF7195 -19-09OCT91-1/1