Multi-Function Handle Linkage Adjustment

If combine "creeps" with multi-funtion control lever in neutral, then adjust as follows:

CAUTION: Control cable is designed and assembled to be non-repairable. Do not attempt to modify or repair cable; replace if damaged.

Do not adjust or install control cable with the engine running, machine may move. Shut off engine, set parking brake and remove key.

Place multi-funtion control lever in neutral. Remove balljoint (A) from pump arm (B) (be certain pump arm is in neutral [spring loaded detent]). Turn balljoint off or on rod until balljoint stud will pass freely into arm hole. Do not move arm from its neutral position.

If adjustment at the ball joint (fine thread end) is not adequate, more adjustment (coarse thread end) is available using the cable bulkhead jam nuts (C). Be certain adequate thread remains in the ball joint and all hardware is tightened.

If creeping still occurs, see your John Deere dealer.

HX,AG,SF7207 -19-19MAY99-1/1