|
Uneven or bunched feeding of crop to cylinder.
|
Header auger too high.
|
Adjust auger down and back. See header operator's manual.
|
|
|
Buildup of grain on cutterbar.
|
Lower reel and set fore-and aft position as close as possible to cutterbar and auger. See platform operator's manual.
|
|
|
Front of feeder conveyor chain adjusted too high.
|
Adjust feeder drum so conveyor slat clears bottom with correct clearance.
|
|
|
Feeder conveyor chain too tight and holds drum up.
|
Adjust conveyor chain to correct tension.
|
|
|
Header drive belt slipping.
|
Spring-loaded idler must be free and tight against belt.
|
|
|
Auger too far ahead of stripper.
|
Adjust auger back to stripper. See header operator's manual.
|
|
|
Feeder conveyor drive chain not on correct sprocket.
|
Place chain on correct sprocket.
|
|
|
Feeder conveyor slats bowed up.
|
Straighten or replace bent slats.
|
|
|
Dirt and sap buildup on feeder house bottom.
|
Clean bottom.
|
|
|
Too great a distance between platform auger and feeder house front drum.
|
Add links to feeder house chain.
|
|
Header or Reel Will Not Lift Correctly
|
Air in hydraulic system.
|
Tighten clamps on leaking lines or hoses. Bleed reel lift system. See Platform operator's manual.
|