Replacing Unloading Auger Drive Belt

CAUTION: Set parking brake, shut off engine and remove key.

Be certain drive is disengaged.

Remove four bolts (A) and trap (B).

Loosen belt trap (C). Remove both belts (D).

IMPORTANT: Always replace both belts as a matched set to insure equal wear.

Adjust belt trap (C).

Install belt trap (B).

If the unloading auger drive will not shut off (disengage) as the new belts stretch (See Unloading Auger Drive Cylinder Adjustment in this manual).

A-Bolts
B-Trap
C-Belt Trap
D-Belts

OUO1035,000030A -19-20SEP00-1/1