|
Clean combine inside and out. Leave elevator doors and drain covers open.
Cycle concave up and down several times to prevent material buildup in the concave area.
IMPORTANT:
Do not use high pressure washer spray directly on bearings. High pressure water can get past most seals and cause damage. Dry these areas, then lube and run combine.
Repaint areas where needed.
NOTE:
It is not necessary to wax your combine. However, if desired, use a good clear wax that
|
contains no abrasives. These type of waxes usually do not contain cleaners.
Lubricate combine and grease adjusting bolt threads.
Perform all 400 hour (yearly) service.
Fill fuel tank to prevent condensation.
If combine is to be stored for a long period of time remove and clean batteries. Store them in a cool dry place and keep them charged.
|