Bottom Feeder House Door and Feedplate Seal Support

CAUTION: Raise feeder house, lower safety stop, shut off engine, remove key, and set parking brake.

Move lever (A) down and to rear to open door.

IMPORTANT: Lever will be bent if left open when feeder house is lowered.

Pull lever forward and up to close.

A-Lever

OUO6035,000006C -19-09NOV00-1/2

If feeder house door is not sealing tight at (A) grain leakage could occur.

Loosen cap screws (B) on both sides.

Turn eccentric (C).

Tighten cap screw securing eccentric.

Tighten remaining cap screws.

A-Seal
B-Cap Screws
C-Eccentric

OUO6035,000006C -19-09NOV00-2/2