Adjusting Unloading Auger Drive Cylinder

If the unloading auger drive will not shut off (disengage), or if the belts jump off as they stretch from use, the cylinder rod stop may need adjustment.

A belt that has stretched can cause the drive not to shut off. The belt rotating around the belt trap can fold over and make contact with the upper sheave.

To adjust the stop:

CAUTION: Set parking brake, shut off engine and remove key.

Mark present stop position on rod with tape (A).

Loosen nut (B) to relieve spring tension.

Loosen bolts (C) and slide stop (D) toward cylinder 13 mm (1/2 in.).

Tighten bolts (C).

Tighten nut (B) to its original position.

NOTE: When installing new belts, adjust stop to its original position (stop positioned against barrel of cylinder with rod fully retracted).

A-Tape
B-Nut
C-Bolts
D-Stop

OUO6035,0000085 -19-09NOV00-1/1