Header Drive Electromagnetic Clutch

CAUTION: Shut off engine, set park brake and remove key.

If the clutch will not work, check the following:

Check and tighten all electrical connections between clutch and batteries. Examine wiring and repair as needed.

Clean any grease from drive plate friction surface. Check drive plate for free movement.

Voltage across hot terminals must be 11 volts minimum with engine off and electric clutch on. If voltage light on the display panel is off, the electrical system has a minimum of 11 volts.

If these checks do not correct the problem, see your John Deere dealer.

OUO6035,0000087 -19-09NOV00-1/1