Transporting Combine on a Trailer

causym CAUTION: Avoid collisions with other roadway users. Before transporting on a public roadway check and follow local regulations regarding the use of lights, flags, over-width signs, pilot vehicles and other requirements for wide loads.

1. Empty grain tank, remove header and remove outside dual wheels (if equipped).

2. To reduce overall height, swing unloading auger back, fold down grain tank extensions (A) (if equipped).

3. Remove quick-lock pin (B) and sample trough.

4. Release clamps (C) and lower auger.

5. Remove outside dual wheels (if equipped).

6. Drive combine on trailer and put multi-function (hydro) handle in neutral.

7. Stop engine, remove key and set parking brake.


A-Grain Tank Extension
B-Quick-Lock Pin
C-Clamps

H53099
H51541
H51542

OUO6075,0000095 -19-20NOV00-1/11


8. Fold radio antenna (A) down.


A-Radio Antenna

H54147

OUO6075,0000095 -19-20NOV00-2/11


9. Tape exhaust pipe cap (A) closed to prevent damage to turbocharger.


A-Exhaust Pipe Cap

H42609A

OUO6075,0000095 -19-20NOV00-3/11


10. Swing both left-hand and right-hand warning lamps (A) rearward.


A-Warning Lamps

H65144

Left-Hand Warning Lamp

H65145

Right-Hand Warning Lamp

OUO6075,0000095 -19-20NOV00-4/11


11. Attach arm (A) to unloading auger and rear hood with pins (B).


A-Arm
B-Pins

H55147

OUO6075,0000095 -19-20NOV00-5/11


12. Wire down engine cover (A).


A-Engine Cover

H55150

OUO6075,0000095 -19-20NOV00-6/11


13. Wire down rear access door at rear wall.

H55151

OUO6075,0000095 -19-20NOV00-7/11


14. Wire down ladder extension and platform (A).


A-Ladder Extension and Platform

H61818

OUO6075,0000095 -19-20NOV00-8/11


15. Make sure that pin (A) is installed through locking plate (B) and retained with spring pin at front corner of right-hand gull wing door and door latch (C) is fully engaged.

16. Wire down door at latch (C).


A-Pin
B-Locking Plate
C-Door Latch

H62857
H62988
H62121

OUO6075,0000095 -19-20NOV00-9/11


17. Make sure pins (A) are installed through locking plates (B) and retained with spring pins at front and rear corners of left-hand gull wing doors and door latch (C) is fully engaged.

18. Wire down left side gull wing door at door latch (C).


A-Pins
B-Locking Plate
C-Door Latches

H64205

Left-Hand Front Corner Pin

H62989
H62990

OUO6075,0000095 -19-20NOV00-10/11


19. Cover up slow moving vehicle emblem (A).

IMPORTANT: Fasten combine to trailer with chains.

20. Fasten combine to trailer with chains.


A-Slow Moving Vehicle Emblem

H63637

OUO6075,0000095 -19-20NOV00-11/11