IMPORTANT:
Change oil every 100 hours if fuel is more than 0.5 % sulfur.
Change oil every 250 hours when using TORQ-GARD SUPREME
®
PLUS-50
®
Do not operate engine with oil level below low mark on dipstick.
1.
Engine Crankcase Filter-Remove old filter (A) and coat seal on new filter with oil. Hand tighten then
|
tighten 1/2 turn more. Turn handle (B) to drain oil. (after first 100 hours only).
Pull cap to fill. Check oil at dipstick (C) after filling .
2.
Clean out end of air conditioning drain hose. Be certain valve (D) is installed on end of hose.
3.
Chopper Bearings. Both sides.
|