A-Plug
B-Dipstick
C-Fill Hole

D-Drain Hole
E-Drain Hole
F-Check Hole

G-Fill Hole
H-Tube

I-Block
J-Check Hole

1. Primary Countershaft Gear Case-Drain at plug (A) and refill at dipstick (B). Oil level must show on knurled part of dipstick.

2. Reverser Gear Case-Raise feeder house and lower safety stop. Drain at (D) and refill at (C). Check with feeder house all the way up. Oil level must show on knurled part of dipstick.

3. Final Drives-Drain at (E) and refill at (G) to within 12 mm (1/2 in.) of bottom of check hole (F). (If you can touch oil with your little finger, you do not need to add oil).

4. Transmission-Slide tube (H) out of block (I). Remove block to drain. Fill at hole (J) to within 12 mm (1/2 in.) of bottom of hole.

OUO6075,000012C -19-01DEC00-1/1