|
Cleaning outside of machine:
Wash outside of machine using power washer.
Use soft absorbent cloth wipe off water droplets.
Use a good clear wax or glazing compound that contains no abrasives and lint free towel.
To apply wax or compound: Put compound on cloth and rub into panel in a circular motion after compound is rubbed into the surface well, turn the towel over and buff out with the other (dry) side.
Cleaning plastic parts:
NOTE:
Do not clean plastic parts with fuel or other petroleum based cleaners.
NOTE:
Always follow manufacturers directions when using cleaner and test on a small hidden area first.
Some of machine's trim parts are plastic. Use tar and road oil remover to remove dirt, wax buildup and other deposits.
Vinyl and Plastic:
Remove dust and dirt with a whisk broom or vacuum cleaner. Clean vinyl surfaces with leather and vinyl cleaner.
|
Clean surfaces with clean, soft damp cloth.
For more thorough cleaning wipe surface with soft cloth and mild detergent.
Remove excess with clean dry cloth.
Cleaning Fabric:
Remove dust and loose dirt with whisk broom or vacuum cleaner.
Remove excess staining material by scraping or wiping with clean cloth.
NOTE:
Always follow manufacturers directions when using fabric cleaner and test on a small hidden area first.
For water soluble stain use a damp cloth first, followed by a soft cloth with a mild detergent and water.
For grease, oil, tar or other petroleum based stains apply fabric cleaner to soiled following manufactures directions.
|