A-Nut

B-Cap Screw

C-Spacers

D-Blades

Remove nut (A), cap screw (B), hardened washers, spacers (C) and blades (D).

Install new blades and retain using cap screw, hardened washers, spacers and nut.

Tighten nut to specifications.

Specification

OUO6075,0000133 -19-01DEC00-1/2

IMPORTANT: Chopper balance must be maintained. When replacing one broken blade, eight blades must be replaced in the proper locations to maintain chopper balance.

For example: If blade (A) is broken, blade (B) on the same support and opposing blades (C) and (D) must be replaced, as well as (E), (F), (G) and (H) on the opposite side of the rotor.

Replacement blades are sold in sets of eight.

A-H-Blades

OUO6075,0000133 -19-01DEC00-2/2