VISIONTRAK™ Display Control Switches

A-Calibration Switch
B-Up Arrow Switch
C-Seed Select Switch
D-Down Arrow Switch

VISIONTRAK is a trademark of Deere & Company

OUO6075,0000138 -19-01DEC00-1/4

Pressing and releasing the seed size switch will increment the seed size by one. When the largest size is reached the next increment will result in the smallest seed size being shown. The last seed size displayed will be kept in the memory when the combine is turned off. When the combine is powered up the last seed size will be displayed.

OUO6075,0000138 -19-01DEC00-2/4

Pressing and releasing either arrow switch will cause the unit to blank the deck plate icon (if equipped), and momentarily display the current grain loss calibration setting for the grain loss monitor. While the current calibration is displayed, pressing the up or down arrow will change the calibration setting.

OUO6075,0000138 -19-01DEC00-3/4

Calibration switch is used to calibrate the grain loss total based on the current loss levels of each sensor.

NOTE: Using this switch in the diagnostics/calibration mode will not change any calibrations for the VISIONTRAK ™ monitor.

VISIONTRAK is a trademark of Deere & Company

OUO6075,0000138 -19-01DEC00-4/4