Detaching Row-Crop Head from Sidehill 6620 Combines (610001-     )

Sound horn, start engine and raise row-crop head all the way up. Shut off engine, set parking brake and remove key.

Disconnect chain (A) and lower safety stop (B) on cylinder (C).

A-Chain
B-Safety Stop
C-Cylinder

AG,OUO1035,2033 -19-23MAR00-1/5

(Both Sides) Loosen cap screw (B) on inner end and remove cap screw (A). Then disconnect telescoping drive shaft at feeder house (shafts stay with header).

Disconnect DIAL-A-MATIC ™ header height control harness if so equipped.

A-Cap Screw
B-Cap Screw

DIAL-A-MATIC is a trademark of Deere & Company.

AG,OUO1035,2033 -19-23MAR00-2/5

(Both Sides) Slide bolt (B) in and down to unlock pin (A) from row-crop head.

Raise safety stop and hook on chain.

Sound horn, start engine and lower feeder house until row-crop head is on ground and attaching blocks are free.

Drive rearward slowly until feeder house is clear of row-crop head. Shut off engine, set parking brake and remove key.

A-Pin
B-Bolt

AG,OUO1035,2033 -19-23MAR00-3/5

Disconnect both variable feeder house hoses at couplers (A) on left side of feeder house ONLY if changing to a platform.

A-Couplers

AG,OUO1035,2033 -19-23MAR00-4/5

IMPORTANT: Hoses must be connected when using a row-crop header. Connect the combine pressure hose to return hose as shown. If connection is not made, hydraulic system can be damaged as constant operation of relief valve will cause overheating.

Route hoses (A) through holder (B) and store on holder (C).

A-Hoses
B-Holder
C-Holder

AG,OUO1035,2033 -19-23MAR00-5/5