Bleeding the System

If hoses have been disconnected from cylinder, or if reel will not remain level with cutterbar, trapped air must be bled from cylinders and lines. This requires two people.

900CP,RA,E -19-18AUG97-1/2

CAUTION: When performing this operation, lower cylinder safety stops.

Open bleed plug (A) in cylinder on right-hand side.

Raise reel and hold switch until oil is free of air bubbles.

Tighten plug.

IMPORTANT: Bleed plug must be tight or air will get into system again.

A-Plug

900CP,RA,E -19-18AUG97-2/2