Hydraulic Adjustment of Reel-Fore/Aft (Attachment)

This attachment will hydraulically position the reel. The position of the reel is controlled from the cab.

If the cylinders become unevenly extended during operation, rephase them by fully retracting the cylinders and holding control switch to remove air from system.

Be sure to position the pin at front of the cylinders so the reel will not get into the auger or auger fingers when cylinders are fully retracted.

IMPORTANT: Inner covers must be removed from flex dividers to avoid damage to reel or dividers. Reel height must be checked wit reel positioned directly above cutterbar.

900CP,RA,K -19-18AUG97-1/1