Load New Software
NOTE:
All software, (mobile processor, display, position receiver, and moisture sensor) are installed using the same procedure.
Whenever new or revised software programs are available, it will be necessary to load new software to the system.
To load new software:
1.
Install PC Card containing new software into top slot A of mobile processor.
2.
Turn ignition key to RUN position.
3.
Press INFO button.
|
|
|
|
OUO6075,0002302 -19-13AUG02-1/7
|
|
4.
Press letter button next to Reprogram.
|
|
|
|
OUO6075,0002302 -19-13AUG02-2/7
|
|
5.
INFO - Software screen will appear. Please letter button next to Program Target.
|
|
|
|
OUO6075,0002302 -19-13AUG02-3/7
|
|
6.
Press letter button next to desired component on program target screen.
|
|
|
|
OUO6075,0002302 -19-13AUG02-4/7
|
|
NOTE:
To return to program target screen and cancel new software load press G.
7.
Press letter button next to software version desired.
|
|
|
|
OUO6075,0002302 -19-13AUG02-5/7
|
|
8.
Wait until WARNING PROGRAMMING screen appears and follow directions on screen.
DO NOT REMOVE PC Card
DO NOT REMOVE POWER
|
|
|
|
OUO6075,0002302 -19-13AUG02-6/7
|
|
9.
When programming is complete, the PROGRAMMING COMPLETE screen will appear. CYCLE POWER will be displayed in the lower left corner.
10.
Turn ignition switch OFF. You may start the combine and proceed as usual.
|
|
|
|
OUO6075,0002302 -19-13AUG02-7/7
|
|
