Recording

The recording screen shows data recording status.

To start recording data, all of the following must occur:

1. Separator engaged.
2. Header engaged.
3. Engine at high throttle position.
4. Header lowered.

To stop recording, one of following must occur:

1. Header raised for more than selected time delay, which is set on Record Stop Delay or raised past Record Stop Height set point. (see RECORD STOP DELAY or RECORD STOP HEIGHT in YIELD MONITOR SETUP FUNCTIONS section).
2. Header disengaged.
3. Key F pressed (to manually stop recording data).

OUZXMAG,0001267 -19-18OCT01-1/2

Recording can be manually stopped and restated without raising the header or shutting off the separator (for example, when approaching areas such as headlands, end rows already harvested, waterways, etc., for which recording data is not desired).

NOTE: When recording has stopped, the word FIELD (A) will appear, which indicates that the values are field averages for yield dry, yield wet and moisture.

To manually stop recording, press F. Display will change to RECORDING IS: OFF, and black arrow will toggle to START.

To resume recording data, press F or push header lower button on the combine multi-function handle (a slight touch to the header lower button will start recording data). Display will change to RECORDING IS: ON, and black arrow will toggle to STOP.

OUZXMAG,0001267 -19-18OCT01-2/2