Record Stop Height (CTS from SN 070231, CWS, STS and WTS)

NOTE: Screen Selection E changes to the correct method of Record Stop when correct model is selected.

At and above this height, the system will automatically stop recording yield data. Below this height the recording data will start automatically, provided all other conditions are met (separator on, proper elevator speeds, etc.). This height will be displayed as a percentage of feeder house angle (0% down, 100% up) and is found on INFO - Diagnostics - PAGE 3.

To change recording stop height:

2. Press E to save new Recording Stop Height.

3. During height position storing, SAVED will be displayed during 3 seconds.

4. The new record stop height is then stored.

OUZXMAG,0001311 -19-29OCT01-1/1