Adjusting Platform Cutterbar/Skid Plate Tilt (Rigid)
NOTE:
If attaching platform to a pre 60 series combine, see Retrofit 600 Series Platform to Pre 60 Series Combines/Wedge Kits section.
Tilt adjustment is used to set the correct relationship between cutterbar/skid plates and ground. It is intended to compensate for tire size and other variables. It should be set so that skid plates are parallel to groundline when contacting the ground.
Platform tilt is adjusted by changing the angle of the feeder house tilt frame. See combine Operator's Manual for procedure to adjust feeder house fore/aft tilt frame (60 series only).
|