Adjusting Auger Fore/Aft

causym CAUTION: Avoid serious injury. Raise platform and reel completely, set safety stops.

causym CAUTION: Avoid serious injury. Shut off engine and remove key.

causym CAUTION: Avoid serious injury from cutterbar movement when auger is turned. Remove knife drive belt (see Remove Knife Drive Belt From Drive Sheave section).

IMPORTANT: To avoid damaging floor or fingers, maintain a minimum 16 mm (5/8 in.) clearance between center auger fingers and floor.

1. Loosen nuts (A).

2. Loosen or tighten nuts (C) and (B) to gain desired auger position.

NOTE: Check auger chain tension (see "Adjusting Auger Chain").

3. Tighten nuts (A-C) and auger drive chain idler (see "Adjusting Auger Chain").

4. Repeat procedure on opposite end of auger.

H64123

Right-hand side shown


A-Nut (2 used)
B-Nut
C-Nuts

OUO6091,0001689 -19-12MAR04-1/1