|
Shut off header and separator.
Note initial setting of concave and then adjust concave to wide open position.
Shut off engine, set park brake and remove key.
Raise straw chopper.
Remove covers to access the discharge beater area and remove crop material from the beater area.
Remove shields over discharge beater drive pulley, so pulley can be rotated by hand.
After clearing the plug, rotate beater one revolution to be sure it is free.
Shift single tine separator drive gear case to neutral.
Remove belt tension from feed accelerator drive by pushing lever up and out from notch in bracket.
Sound horn, start engine and set engine speed at mid idle.
|
Engage separator to clean out material from the discharge beater and chopper.
Shut off separator.
Shut off engine, set park brake and remove key.
Shift single tine separator drive gear case to original speed.
Engage feed accelerator drive by pushing the lever up and into the notch in bracket.
Re-install all shields.
Lower straw chopper to operating position.
Sound horn, start engine and set engine speed at mid idle.
Engage separator.
Set concave spacing back to initial setting and resume operation.
|