HARVESTSMART Feed Rate Control Drive By Wire

Machine stops unexpectedly and will not move.

System has a component out of tolerance.

Return multifunction control handle to neutral and clear all error codes. After codes are cleared try to drive machine.

System has lost one or more of the redundancy channels.

To get machine to move or to get machine out of the way, go to LIMP mode. Go to address E13 address 50 and change the zero to a one. THIS IS ONLY TO GET MACHINE MOVED TO SAFETY. THIS IS NOT TO BE USED FOR NORMAL OPERATION. Call your John Deere dealer to have machine inspected.

Machine will stop after driver is out of seat for three seconds.

Operator out of seat.

Operator must return to seat and return multifunction control handle to neutral before operation can resume.

OUO6075,0003976 -19-29JUN04-1/1