|
IMPORTANT:
Change oil every 100 hours if fuel is more than 0.5 % sulfur.
Fill crankcase with seasonal viscosity grade oil or TORQ-GARD SUPREME
(250 hours change interval). If using PLUS-50
oil and a John Deere filter, service interval can be extended by 50 percent. Example: 250 Hours extends to 375 Hours.
Do not operate engine with oil level below low mark on dipstick.
|
1.
Engine Crank Case Filter - Remove and replace filter (A). Coat seal on new filter with oil before hand tightening. Tighten filter 1/2 turn more after contact. Open drain (B) to remove oil.
2.
Remove cap (C) to fill and remove dipstick (D) to check.
3.
Fuel Tank Breather - Visually inspect fuel tank breather (E). Do not allow excessive amounts of chaff to collect on breather. Remove fuel tank breather from hose (F) and clean.
|