| Control Unit |
SPN |
FMI |
Pri. |
Description |
| C00 |
627 |
03 |
1 |
Delayed Power (cc# 006) voltage is above 16 VDC. High voltage situation must be resolved. |
| C00 |
628 |
12 |
1 |
Controller cannot exit boot block program. Disconnect effected control unit connectors. Wait 30 seconds. Reconnect connectors. Reprogram controller with latest software. Replace control unit if condition persists. |
| C00 |
630 |
11 |
1 |
Controller failed EEPROM test at power-up. Replace Armrest Control Unit if condition persists. |
| C00 |
1490 |
08 |
2 |
Feeder house speed unknown. Damage could occur to feeder house if direction is changed while feeder house is turning. |
| C00 |
1499 |
12 |
2 |
The separator engage fault detection circuit indicates a failure. This is an important disengagement override system. Replace the Armrest Control Unit if condition persists. |
| C00 |
1504 |
11 |
1 |
The Seat Switch has been closed continuously for 6 hours. The switch or the wiring harness is shorted. The header will not disengage when the operator has left the seat. This must be corrected. |