Feed Accelerator-Wing Replacement

causym CAUTION: Shut OFF engine, set parking brake and remove key.

NOTE: Wings can be reversed for additional wear.

Feed accelerator wings and feed accelerator wear strips can be replaced without removing the feed accelerator. Replace accelerator wings in sets of two and opposite of each other on the accelerator to maintain proper balance.

NOTE: If accelerator is removed from combine, or has been serviced, tighten clamp bolts before securing wings. Tighten cap screws to specification.

Remove round head bolts (A) and replace feed accelerator wear strips (B) as required. Tighten round head bolts to specification.

Specification

Feed Accelerator Wear Strip Round Head Bolts -Torque 70 N·m (52 lb-ft)

Remove cap screws (C) and replace feed accelerator wings (D) as required. Tighten cap screws to specification.

Specification

Feed Accelerator Wing Cap Screws -Torque 70 N·m (52 lb-ft)


A-Round Head Bolt(s)
B-Feed Accelerator Wear Strip
C-Cap Screws
D-Feed Accelerator Wings

H85626

Feed Accelerator Wing (Standard)

H85627

Feed Accelerator Wing (Standard)

H81772

Feed Accelerator Wing (Rice)

H79440

Feed Accelerator Wing (Rice)

OUO6075,000036E -19-13APR06-1/1