| Control Unit |
SPN |
FMI |
Pri. |
Description |
| E04 |
627 |
03 |
1 |
Delayed Power (cc# 006) voltage is too high - greater than 15.5 VDC. (STS models only) |
| E04 |
628 |
12 |
2 |
Controller cannot exit boot block program. Disconnect Left Control Unit2 connectors X314 and X315. Reconnect connectors. Replace Armrest Control Unit if condition persists. (STS models only) |
| E04 |
1388 |
03 |
2 |
Rotor Drive Pressure (cc# 723) voltage is too high - greater than 4.98VDC. (9860 STS) |
| E04 |
1388 |
04 |
2 |
Rotor Drive Pressure (cc# 723) voltage is too low - less than 0.20 VDC. (9860 STS) |
| E04 |
1503 |
09 |
2 |
CAN Bus message(s) missing from Armrest Control Unit (STS models only) |