Machine slows way down or stops when HARVESTSMART Feed Rate Control is activated.
|
Machine has a bad calibration value.
|
Recalibrate system.
|
After calibrating the system the machine drives too slow.
|
Target load torque is too low.
|
Press up arrow on VISIONTRAK display two or three times.
|
|
Machine has a bad calibration value.
|
Recalibrate system.
|
After calibrating the system the machine drives faster than desired.
|
Target rotor torque is too high.
|
Press down arrow on VISIONTRAK two or three times.
|
|
Machine has a bad calibration value.
|
Recalibrate system.
|
With HARVESTSMART Feed Rate Control active the machine is oscillating speed too much.
|
Gain/Aggressiveness is set too high.
|
Decrease response setting.
|
|
Loss monitor too sensitive.
|
Try running HARVESTSMART Feed Rate Control System on capacity (CPCTY) mode.
|
With HARVESTSMART Feed Rate Control active the system seems sluggish to respond to changes.
|
Gain/Aggressiveness is set too low.
|
Increase response setting.
|
HARVESTSMART Feed Rate Control is operating erratically.
|
Machine has a bad calibration value.
|
Recalibrate system.
|
|
Loss monitor not working properly.
|
Try running HARVESTSMART Feed Rate Control on capacity (CPCTY) mode.
|