|
NOTE:
If error codes occur during calibration procedure, codes will show on CommandCenter display. Conditions causing error must be corrected before continuing calibration.
IMPORTANT:
Threshing Clearance Calibration should not be completed with round bar concave covers installed. An incorrect zero position may result.
-
Threshing Clearance Calibration -
Perform calibration when control unit LC1, threshing clearance sensor or associated components are replace/adjusted.
-
Header Calibration -
Perform calibration;
-
If control unit LC1 has been replaced.
-
If a header height control sensor or associated components are replaced/adjusted.
-
First time each header is connected to combine.
-
Feeder House Speed Calibration -
Perform calibration;
-
If control unit LC1 has been replaced.
-
First time each header is connected to combine.
-
If attachments of significant weight is added to or removed from head.
-
Chaffer Opening Calibration -
Perform calibration when control unit LC2 or chaffer actuator has been replaced/adjusted.
|
-
Sieve Opening Calibration -
Perform calibration when control unit LC2 or sieve actuator has been replaced/adjusted.
-
Corn Head Deck Plate Calibration -
Perform calibration when control unit LC1 or deck plate position sensor or associated components are replaced/adjusted.
-
Smart Feed Rate Handle Calibration -
Perform calibration when control unit VCM, handle position sensor are replaced/adjusted.
-
Smart Feed Rate Valve Calibration -
Perform calibration when control unit VCM, forward solenoid or reverse solenoid has been replaced.
-
Moisture Calibration -
Perform calibration when control unit HMM or associated components are replaced/adjusted.
-
Yield Calibration -
Perform calibration when control unit HMM or associated components are replaced/adjusted.
-
Service Hours Calibration -
Reset Service Hours.
|