|
NOTE:
All Calibration:
See calibrations for your platform in your Combine's Operator's Manual.
Calibration procedures must be performed before first use or if header height control sensor, deck plate position sensor or associated components are replaced.
-
Header Calibration -LC1 (hdr)
-
CONTOUR MASTER Angle Sensor Calibration - LC1 tilt (Optional)
-
Active Float Calibration - FLO
|
NOTE:
The condition causing the error must be corrected before the calibration can be continued.
If any errors occur during the calibration procedures, error codes are displayed:
-
50 and 60 series combine - Triple display tachometer
-
70 series combine - CommandCenter display
|