Machine Profile

General Settings

If display detects machine, some information is automatically set by machine control units.

At this time, profile settings cannot be imported or exported from the display.

Settings specific to certain machine types only appear on page when applicable.

• Articulated Tractor Articulation Point

  Front Axle

  • Distance from articulation point to center of the front axle. Articulation point is the pivoting point of machine when making a turn.

  Rear Axle

  • Distance from articulation point to center of rear axle. Articulation point is the pivoting point of machine when making a turn.
• Track Tractor Center of Rotation

  Center of Rotation

  • Distance from pivot point of the machine to rear axle.

GPS Offsets

• GPS Lateral Offset
  • Lateral distance (left or right) from the center line of the machine to center of GPS receiver. This value is usually set to 0.0 unless GPS receiver is offset left or right of the machine center line. Guidance and Mapping applications require GPS Lateral Offset settings.

• GPS Inline Offset
  • Inline distance from center of the non-steering axle on the machine to center of GPS receiver. Mapping application requires GPS Inline Offset settings.

• GPS Height
  • Vertical distance from GPS receiver to ground.

Connection Offsets

• Inline distance from center of rear axle to connection point. Connection point is location where implement connects to machine. Mapping application requires Connection Offset settings.

Restore Profile to Factory Defaults

Only machines detected by the display can have profile settings restored to factory default.

Default machine profile settings are stored in machine control units. Changes to these settings are stored in the display. To reset profile to factory defaults, select settings at the top of Machine Profile page. Then, select Reset Profile button.

Use Help Center Onscreen Help for more information about Equipment Manager and the Machine Profile.