Fore/Aft Tilt

Fore/Aft Tilt allows you to quickly move the feeder house face Fore and Aft to achieve optimal cutting performance of the header in challenging conditions.

Fore/Aft Tilt minimum and maximum settings are different for each header type.

Modify When:

• Adjust Fore or Aft to prevent pushing or dragging wet or dense residual residue.
• Adjust Fore or Aft to better attach or detach the header.
• Adjust Fore or Aft for optimal conveying of crop material into the feeder house.

Tilt Feeder House Fore:

• Picking up downed crop.
• Cutting closer to the ground.

Tilt Feeder House Fore:

• Material is being pushed by the cutter bar. Move aft to reduce lost material.
• For standing crop, tilting aft can optimize feeding/conveying material into the machine.

H116129-UN-19DEC16

Fore/Aft Tilt

If operating 600F or 600FD, HydraFlex™ Pressure settings also affect header height sensitivity.

1. Select screen area under Fore/Aft Tilt to open Fore/Aft page.

2. 
   H116141-UN-20DEC16

   Adjustment

   Select plus (+) to increase or minus (-) to decrease desired position.

   Minimum and maximum settings will be affected by header type and calibration. See Calibrations application for more information on calibration procedures.

---




3. 
   H116648-UN-19DEC16

   Close

   Select to close.

---

H116140-UN-19DEC16

Input Field

1. Select to activate Navigation Bar and Armrest Adjustment Dials.

2. 
   H115035-UN-14MAR16

   Navigation Bar Adjustment Dial

   
   H115034-UN-28MAR16

   Armrest Adjustment Dial

   Use Navigation Bar or Armrest Adjustment Dial to select desired setting.
   • Turn dial clockwise to increase value.
   • Turn dial counterclockwise to decrease value.
   
   

---