Fore/Aft Resume

Fore/Aft Resume allows you to program a saved fore/aft tilt position of the feeder house frame to any of the Activation buttons 1,2, or 3 on the multi-function lever.

You may have a standard position for harvesting standing crop and then another for downed crop. This allows you to quickly switch back and forth.

Modify When:

  • Riding over wet or dense residual residue.
  • Adjust Fore or Aft to better attach or detach the header.
  • Adjust Fore or Aft for optimal conveying of crop material into the feeder house.

Tilt Feeder House Fore When:

  • Picking up downed crop.
  • Cutting closer to the ground.

Tilt Feeder House Aft When:

  • Material is being pushed by the cutterbar. Move aft to reduce lost material.
  • For standing crop, tilting aft can optimize feeding/conveying material into the machine.

System Is Enabled When:

  • Engine is running.
  • Road transport disconnect switch is in field position.
  • Hydraulic Feeder House Fore/Aft Resume system is ON.
  • Multi-function lever switches are functionally assigned.
  • Head is engaged.

H116962
H116962-UN-19DEC16

Auto Control

Procedure to Modify:

  1. Select Auto Control on Header application main screen.

  2. H116165
    H116165-UN-19DEC16

    ON/OFF

    Select to turn Fore/Aft Resume ON/OFF.

    Depending on machine configurations and the setup of your configurable switches and buttons on the multi-function lever, many combinations exist.


  3. H118577
    H118577-UN-19DEC16

    Programmable Buttons

    To change fore/aft tilt setpoint, press desired programmable button C or D and adjust fore/aft tilt using hydraulic feeder house fore/aft tilt switches.


  4. H116346
    H116346-UN-19DEC16

    Activation Buttons

    Press and hold the desired activation button for 2 seconds to enter desired setting into memory.

    H116354
    H116354-UN-19DEC16

    Activation Number

    Activation number on the corner post display indicates which button was selected.


  5. Push and hold top of switch to tilt feeder house forward or push and hold bottom of switch to tilt feeder house rearward.

    Armrest display shows the feeder house fore/aft tilt position based on a sensor linked to the feeder house.

    Manually moving hydraulic feeder house fore/aft tilt switches on multi-function lever deactivates system.

    Press activation buttons 1, 2, or 3 to reactivate system. Hydraulic feeder house fore/aft tilt automatically moves to preselected position.

    When the feeder house is raised and the header is engaged, feeder house fore/aft tilt automatically moves forward. This allows the feeder house safety stop to be lowered onto hydraulic cylinder rod. Feeder house fore/aft tilt automatically returns to last known position when lowering.

    When the header is disengaged, feeder house fore/aft tilt automatically moves forward upon raising. Feeder house fore/aft tilt will not return to last known position when lowering.

  6. H116648
    H116648-UN-19DEC16

    Close

    Select to close.

SS43267,00007F5-19-20170516