Threshing Clearance (Standard Concave Adjust)

This procedure calibrates Threshing Clearance by identifying the fully opened and closed positions of the concaves. A properly calibrated Threshing Clearance provides the best results for the harvest setting recommendation. See your Operator's Manual for more details.

Calibration should not be completed with round bar concave covers installed. An incorrect zero position results.

Perform Calibration When:

• Before each harvest season.
• Physical concave opening does not match what is being displayed in the cab.
• Concaves are replaced with a new or different set of concaves.
• Threshing clearance sensor, or associated components are replaced/adjusted.

Items Accessible on Threshing Clearance Page:

N120226-UN-23FEB16

Begin Calibration

Requirements—machine state required for calibration.

Details Displayed on Page:

Last Calibration	Date and Time
Recommended Interval	As Needed
Estimated Time Required	Approximately 1-2 min