Reel Position

This procedure calibrates the Reel Position by raising and lowering the reel and moving the reel fore/aft to determine the maximum position to associate the mechanical limits with sensor voltage. Performing this procedure allows the control unit to determine the adjustment limits and allow reel resume functionality.

Perform Calibration When:

• Each header type is connected to the combine for the first time.
• Reel/Cutterbar position sensors or associated components are replaced/adjusted.

Items Accessible on Reel Position Page:

N120226-UN-23FEB16

Begin Calibration

Requirements—machine state required for calibration.

Details Displayed on Page:

Last Calibration	Date and Time
Recommended Interval	As Needed
Estimated Time Required	Approximately 1-2 min