Residue Mode

Select Chop or Windrow Residue Mode option for desired straw and chaff processing.

Select Windrow When:

Select Windrow to leave a windrow of residue behind the machine.

Machines Equipped With Premium Flex Residue System Only: In Windrow mode straw bypasses the chopper while chaff is still being chopped and spread. The straw discharges from the separator into a windrow behind the machine. This leaves a cleaner windrow.

Select Chop When:

Select Chop to send residue through the chopper to minimize residue length.

Windrow Setup:

Non-Premium Flex Residue System: When placed into "Windrow" mode, all other spreader settings are unable to be changed.

Settings return to previous states when changed back to "Chop" mode.

See Operator's Manual for more information on the following out of cab adjustments.

1. Place cob deflector in small grains position.

2. Shift chopper drive into neutral position.

3. 
   H116998-UN-03JAN17

   Windrow

   
   H116639-UN-03JAN17

   Chopper Position

   Select Windrow or place chopper in raised position.

   When harvesting low residue volume crops, lower cob deflector into corn position.

   
   H116644-UN-03JAN17

   Status Indicator

   Status indicator shows status of door.

   
   H116645-UN-03JAN17

   Error Detected

   Premium Flex Residue ONLY: When an error occurs during a close/open process, the system attempts to return to previously selected state prior to your change request. If it is unable to successfully reach that prior state, the "Tailboard Error" message is displayed, and you must make a mode choice again.

---

Chop Setup:

Chop automatically closes the chop-to-drop door. The fine cut chopper cuts the straw discharged from the separator when the chop-to-drop door is closed.

Separator must be OFF to change the position of the chop-to-drop door.

H116997-UN-03JAN17

Chop