Auto Maintain Status

Auto Maintain Status is used to communicate the current state of the Auto Maintain system. Status also allows you to view requirements that must be met for the system to operate properly.

H119193
H119193-UN-30JAN17

Auto Maintain

Select screen area under Auto Maintain to open status page.

Items Displayed on Auto Maintain Status Page:

Not all faults are listed below. Select screen area to open list of current statuses.

H114659
H114659-UN-05JAN17

Blue

Auto Adjustment— applying setting change.

H114659
H114659-UN-05JAN17

Blue

Applying Offsets— continuing to monitor changes.

H114656
H114656-UN-05JAN17

Green

Acquiring New Performance Target

H114656
H114656-UN-05JAN17

Green

Monitoring

H114658
H114658-UN-05JAN17

Amber

Not Ready— action required.

H114657
H114657-UN-05JAN17

Red

Error Detected— attention required.

H114655
H114655-UN-05JAN17

Gray

Automation OFF

Auto Maintain Requirements:

  • Auto Maintain automation must be ON.
  • Crop type must be supported by Auto Maintain.
  • Performance Target must be set.
  • Machine must be ready to harvest:
    • Separator must be engaged.
    • Header must be engaged.
    • Engine must be set to high idle.
    • Road Mode must not be enabled.
  • Must be in consistent crop conditions:
    • Machine must have steady ground speed.
    • Crop flow must be present.
  • Header must be below record stop height.

H113789
H113789-UN-30JAN17

Exclamation Mark

A message appears when a requirement is not met.

H118541
H118541-UN-30JAN17

Select to Access

Select to access the page that corresponds to the unmet requirement.

H119194
H119194-UN-30JAN17

Green Check

Once a condition has been met, a green check appears.

H116936
H116936-UN-30JAN17

Close

Select to close.

SS43267,0000962-19-20170517