Heavy Duty Fuel Precleaner Filter (Optional)-Cleaning

1. Shut OFF engine and close valve (A) at bottom of fuel tank.

NOTE: Use a catch pan when draining fuel.

2. Open drain valve and drain fuel from bowl.


A-Valve

H91170

OUO6075,0000088 -19-16APR09-1/2

3. Loosen lid screws evenly in sequence shown.

4. Remove lid (A) and spring cassette (B).

5. Lift out filter element (C) by handle.

NOTE: Inspect filter for damage. If damaged, install replacement filter.

6. Wash filter in clean diesel fuel or mineral spirits.

7. Install filter element and spring cassette.

8. Inspect lid gasket (D) and replace if necessary.

9. Install lid and cap screws and leave cap screws finger tight.

10. Tighten cap screws in sequence as shown.

11. Open valve at bottom of fuel tank.

12. Turn key switch ON for 60 seconds to allow fuel pump to prime fuel system and check for leaks.

13. Start engine and run 3 to 5 minutes at low idle.

RXA0084320
H91103


A-Cover
B-Spring Cassette
C-Filter Element
D-Gasket

OUO6075,0000088 -19-16APR09-2/2