Limp Mode
To get machine to move or move machine out of way, use the following
LIMP
mode.
Press main menu switch and rotate selection dial until message center icon is highlighted and press confirm switch.
Rotate selection dial until diagnostic address icon is highlighted and press confirm switch.
Rotate selection dial until device (controller) drop menu is highlighted and press confirm switch.
Rotate selection dial until
PTP
controller is highlighted and press confirm switch.
|
Rotate selection dial until address
119
is highlighted and press confirm switch.
Address value will highlight and display
zero
.
Press confirm switch to enter into address value and rotate selection dial until
one
is displayed.
Press confirm switch to enter
one
into memory.
Rotate selection dial until save icon is highlighted and press confirm switch.
NOTE:
ALLOWS MACHINE TO OPERATE UNTIL KEY IS CYCLED. NOT TO BE USED FOR NORMAL OPERATION. Call your John Deere dealer to have machine inspected immediately.
|