Lighting Locations
A-High Intensity Discharge (HID) Cab Headlights
B-Cab Headlights
| C-Beacon Lights
D-Warning Lights
E-Stubble Lights
| F-Warning Lights
G-Warning Lights
H-Beacon Light
| I-Taillights/Stop Lights
J-Discharge Lights
|
Front and Rear View Lights
Beacon/Hazard Light Switch:
CAUTION:
Lights must be turned ON when transporting. Swing cab ladder forward to orient warning light towards oncoming motorists.
-
Switch in middle position controls beacon lights (C, H).
-
Switch in top position controls beacon lights (C, H), warning lights (D, F, G), four road lights (B), and taillights (I) (if engine is running).
-
Beacon lights and warning lights are located on both sides of the machine at the front and rear and give warning to other drivers when transporting on roadways.
|
orient warning light towards oncoming motorists.
-
Switch controls warning lights (D, F, G), four road lights (B), and taillights (I).
-
Warning lights are located on both sides of the machine at the front and rear and give warning to other drivers when transporting on roadways.
Auto Beacon/Field Light Switch:
NOTE:
These lights will not operate when the hazard warning lights are ON.
-
Switch in middle position causes beacon lights (C, H) to illuminate when grain tank is 3/4 full. Beacons provide a signal to the grain cart operator that grain tank is full and is ready to be unloaded.
-
Switch in top position controls auto beacon lights (C, H), warning lights (D, G), taillights (I), and field lights (A, B).
-
Field lights provide operator with area lighting for operation at night and during low light conditions.
|
|
OUO6075,00001F1 -19-01APR09-1/6
|
A-High Intensity Discharge (HID) Cab Headlights
B-Cab Headlights
| C-Beacon Lights
D-Warning Lights
E-Stubble Lights
| F-Warning Lights
G-Warning Lights
H-Beacon Light
| I-Taillights/Stop Lights
J-Discharge Lights
|
Work Lights Switch:
CAUTION:
To avoid motorist confusion, do not operate work lights when transporting on public roadways.
NOTE:
CommandCenter display shows a warning indicator if rear discharge or stubble lights are left ON while transporting.
-
Switch in middle position controls stubble lights (E).
-
Switch in top position controls stubble lights (E) and rear discharge lights (J).
-
Stubble lights provide operator with area lighting behind header for night operation and low light conditions
1
.
-
Rear discharge lights provide operator with rear area lighting for night operation and low light conditions
1
.
|
-
Stop lights (I) come ON when machine senses a deceleration. Lights stay on for a minimum of two seconds.
-
Once speed is less than 1.6 km/h (1 mph), stop lights stay on for two minutes or until forward acceleration is sensed and the speed is greater than 1.6 km/h (1 mph).
-
These lights also act as turn indicators, and illuminate when a turn is signaled. The light in the direction of the turn flashes, while the opposite light stays on (not flashing). If a turn is signaled while machine is decelerating, the turn indicator function has priority over the stop light function.
Exit Lighting:
-
Two inner most cab headlights (B) and exiting lights remain on for a maximum of 90 seconds after key switch is turned OFF (if road or field lights were in use within the previous five minutes). Operator chooses to light left-hand or right-hand side of machine using turn signal lever.
|
|
OUO6075,00001F1 -19-01APR09-2/6
|
A-Grain Tank Light
B-Side Finder Lights
C-Service Door Lights
| D-Cleaning Shoe Lights
E-Engine Compartment Service Lights
| F-Unloading Auger Light
G-Cleaning Shoe Light Switch
| H-Service Lights Switch
I-Engine Compartment Service Lights Switch
|
Left and Right Side View Lights
Auto Beacon/Field Light Switch:
NOTE:
These lights will not operate when the hazard warning lights are ON.
-
Switch in top position controls grain tank light (A), side finder lights (B) (with turn signal lever), and unloading auger light (F).
|
|
|
OUO6075,00001F1 -19-01APR09-3/6
|
-
Unloading auger light comes ON when auger is extended more than 50% with field light switch ON.
-
Unloading auger light provides lighting for unloading grain tank at night or in low light conditions.
|
-
Cleaning shoe lights (D) provide operator with lighting for cleaning shoe adjustment at night or in low light conditions.
-
Cleaning shoe ON/OFF switch (G) is located above left-hand separator shield.
|
|
OUO6075,00001F1 -19-01APR09-4/6
|
A-Grain Tank Light
B-Side Finder Lights
C-Service Door Lights
| D-Cleaning Shoe Lights
E-Engine Compartment Service Lights
| F-Unloading Auger Light
G-Cleaning Shoe Light Switch
| H-Service Lights Switch
I-Engine Compartment Service Lights Switch
|
|
OUO6075,00001F1 -19-01APR09-5/6
|
-
Two inner most cab headlights and side finder lights (B) remain on for a maximum of 90 seconds after key switch is turned OFF (if road or field lights were
|
in use within the previous five minutes). Operator chooses to light left-hand or right-hand side of machine using turn signal lever.
|
|
OUO6075,00001F1 -19-01APR09-6/6
|
|