Chaffer or Sieve Indicator-Calibration

Using adjusting tool to close chaffer completely.

Loosen set screw (A) at left-hand rear corner of chaffer (opening in chaffer frame). Open chaffer slowly until opening measures approximately 8 mm (5/16 in.).

Slide opening gauge in or out until gauge reads 8 mm (5/16 in) (C) from side sheet. Tighten set screw at the rear of chaffer.

This procedure to also used to calibrate the sieve.

A-Set Screw
B-Gauge 8 mm (5/16 in.)

OUO6075,000021D -19-22OCT08-1/1