Every 400 Hours

H93398
H86797
H86798
H86799
H86800
 

A-Primary Countershaft Bearing

B-Separator Bearing

 

1. Tailings Auger Drive Slip Clutch - Rotate sheave assembly to access fitting. Do not over grease.

2. Conveyor Auger Drive Slip Clutch - Rotate sheave assembly to access fitting. Do not over grease.

OUO6075,00002E4 -19-05FEB09-1/2


3. Right-Hand Side Lube Bank - Grease fittings to lubricate primary countershaft bearing (A) and separator bearing (B).

4. Feed Accelerator Bearing (Right Side) - Rotate sheaves to access fitting.

5. Discharge Beater Bearing - Grease fitting (both sides).

6. Cleaning Fan Shaft Bearings - Grease fitting (both sides).

7. Rear Axle Tie Rod - Grease fitting (both sides) on power steering rod end ball joint.

8. Spreader Disk - Grease fitting (both sides) to prevent hubs from corroding to shafts.

OUO6075,00002E4 -19-05FEB09-2/2