A-Hydrostatic Charge Filter
B-Hydraulic/Hydrostatic Filter
C-Plug

D-Dipstick
E-Reservoir Cap

F-Engine Power Take-Off Gearcase Filter

G-Multi-Speed Feeder House/ProDrive Filter

OUO6075,00002E5 -19-05MAR09-1/2

NOTE: It is not necessary to drain system when installing filters.

1. Hydrostatic Charge Filter - Replace hydrostatic charge filter (A). Coat seal on new filter with oil. Hand tighten, then tighten 1/2 turn more.

2. Hydraulic/Hydrostatic Filter - Replace hydraulic/hydrostatic filter (B). Coat seal on new filter with oil. Hand tighten, then tighten 1/2 turn more.

3. Transmission Oil (Non ProDrive Machines) - Remove plug (C) and check oil level. Add oil as needed to within 12 mm (1/2 in.) of bottom of hole.

4. Primary Countershaft Gearcase Oil (Non Multi-Speed Feeder House Machines) - Check

5. Brake Fluid (Non ProDrive Machines) - Check brake fluid level. Look through reservoir cap (E). Add brake fluid to 6 mm (1/4 in.) from top. Do not let dirt get into brake fluid.

6. Engine Power Take-Off Gearcase Filter - Replace engine gearcase filter (F). Coat seal on new filter with oil. Hand tighten, then tighten 1/2 turn more.

7. Multi-Speed Feeder House/ProDrive Filter (Optional) - Replace multi-speed feeder house/ProDrive filter (G). Coat seal on filter with oil. Hand tighten, then tighten 1/2 turn more.

OUO6075,00002E5 -19-05MAR09-2/2