|
1.
Separator Drive - Remove dipstick (A) and check oil level. Oil level should be between grooves on dipstick. Add oil as needed.
2.
Final Drive Oil - Remove plug (B) and check oil level (both sides). Oil should be within 12 mm (1/2 in) of bottom of hole. Add oil as needed.
NOTE:
Loading auger gearcase does not need to be drained.
|
3.
Loading Auger Gearcase - Check oil level with dipstick and add oil as needed.
4.
Feeder House Slip Clutch - Grease fitting on upper feeder house slip clutch, until grease is forced out past seal.
|
