OUO6075,00002EC -19-05FEB09-1/2

A-Hydraulic Hose
B-Cap
C-Sight Glass
D-Drain Plug

E-Fill Plug
F-Check Hole
G-Drain Plugs
H-Dipstick

I-Protective Cap
J-Drain Valve
K-Dipstick
L-Cap

M-Dipstick
N-Tube
O-Block
P-Check Plug

NOTE: Before removing hydraulic hose, refer to Specifications section for hydraulic reservoir capacity.

1. Hydraulic/Hydrostatic Reservoir Oil - Remove hydraulic hose (A) to drain. Clean screen and cap (B) and refill reservoir. Oil level must show in middle on sight glass (C).

2. Engine Valve Back Lash - Have engine valve back lash checked and adjusted if necessary, by your John Deere dealer.

3. Final Drives Oil (both sides) - Remove drain plug (D) to drain. Remove fill plug (E) to refill until oil level is within 12 mm (1/2 in.) of bottom check hole (F).

4. Engine Power Take-Off Gearcase Oil (Non ProDrive and Non Multi-Speed Feeder House

5. Separator Drive Oil - Remove protective cap (I) and attach hose to drain valve (J). Open valve to drain. Refill at dipstick (K) as needed.

6. Primary Countershaft Gearcase Oil (Non Multi-Speed Feeder House Machines) - Drain at cap (L) and refill at dipstick (M). Oil level must show on knurled part of dipstick.

7. Transmission Oil (Non ProDrive Machines) - Slide tube (N) out of block (O). Remove block to drain. Remove check plug (P) and refill to within 12 mm (1/2 in.) of hole.

OUO6075,00002EC -19-05FEB09-2/2