Unloading Auger Support Stud-Adjusting (Standard Grain Tank)

causym CAUTION: Shut OFF engine, set parking brake and remove key.

NOTE: Periodically verify that auger fully slides into support stud when auger is fully retracted. Adjust support stud as needed.

1. Loosen nuts (A) to adjust position of stud plate (B).

2. Clearance (C) between top of stud (D) and slot, must be set to specification.

Specification

Top of Stud to Slot -Clearance 0-3 mm (0-1/8 in.)

3. Adjust stud plate as needed and tighten nuts.

H73125


A-Hardware
B-Plate
C-Clearance
D-Stud

OUO6075,0000343 -19-13APR09-1/1